Home › Engine / Hybrid System › 1NZ-FXE (ENGINE MECHANICAL) › CYLINDER HEAD
RM2170E _51 Engine / Hybrid System _057005 1NZ-FXE ENGINE MECHANICAL _0277950 CYLINDER HEAD A

1NZ-FXE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 1.REPAIR INTAKE VALVE SEATS

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free of foreign matter.



a.
A267072E01
2.103,1.833 2.265,2.001 0.162,0.168 10 *a 2.735,0.299 2.980,0.468 0.244,0.168 10 45° 2.913,0.591 3.157,0.759 0.244,0.168 10 20°

If the seating is too high on the valve face, use 20° and 45° cutters to correct the seat.

Text in Illustration
*a Width

Valve seat width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



b.
A267073E01
2.088,1.821 2.251,1.987 0.163,0.166 10 *a 2.127,0.122 2.364,0.274 0.237,0.152 10 75° 2.726,0.357 2.963,0.509 0.237,0.152 10 45°

If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.

Text in Illustration
*a Width

Valve seat width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



c.

Hand-lap the valve and valve seat with an abrasive compound.


d.

Check the valve seating position.


Hide 2.REPAIR EXHAUST VALVE SEATS

NOTICE:
·

Repair the seat while checking the seating position.

·

Keep the lip free of foreign matter.



a.
A267072E01
2.103,1.833 2.265,2.001 0.162,0.168 10 *a 2.735,0.299 2.980,0.468 0.244,0.168 10 45° 2.913,0.591 3.157,0.759 0.244,0.168 10 20°

If the seating is too high on the valve face, use 20° and 45° cutters to correct the seat.

Text in Illustration
*a Width

Valve seat width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



b.
A267073E01
2.088,1.821 2.251,1.987 0.163,0.166 10 *a 2.127,0.122 2.364,0.274 0.237,0.152 10 75° 2.726,0.357 2.963,0.509 0.237,0.152 10 45°

If the seating is too low on the valve face, use 75° and 45° cutters to correct the seat.

Text in Illustration
*a Width

Valve seat width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



c.

Hand-lap the valve and valve seat with an abrasive compound.


d.

Check the valve seating position.