Home › Engine / Hybrid System › 1NZ-FXE FUEL › FUEL PUMP › 2011.12–2017.06
RM2170E _51 Engine / Hybrid System _057006 1NZ-FXE FUEL _0277955 FUEL PUMP G

1NZ-FXE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23220A 1.INSPECT FUEL PUMP WITH FILTER ASSEMBLY

a.
A192531E03
1.604,0.573 1.385,1.094 false 1.823,0.573 2.042,1.094 false 1.302,1.125 1.5,1.375 0.198,0.25 10 1 2.031,1.104 2.229,1.354 0.198,0.25 10 2

Check the fuel pump resistance.

i.

Using an ohmmeter, measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump with filter assembly.



b.

Check fuel pump operation.

i.

Apply auxiliary battery voltage to terminals 1 and 2. Check that the pump operates.

NOTICE:
·

These tests must be done quickly (within 10 seconds) to prevent the coil from burning out.

·

Keep the fuel pump as far away from the auxiliary battery as possible.

·

Always switch the voltage on and off on the auxiliary battery side, not the fuel pump side.



If the pump does not operate, replace the fuel pump with filter assembly.