12204
1.INSTALL VENTILATION VALVE SUB-ASSEMBLY
Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.
Toyota genuine adhesive 1324, three bond 1324 or equivalent
Using a ball joint lock nut wrench (19 mm), install the ventilation valve sub-assembly.
Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a ball joint lock nut wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Install the No. 1 ventilation hose.
Install the wire harness with the 2 bolts.