Home › Engine / Hybrid System › 1NZ-FXE EMISSION CONTROL › CANISTER › 2011.12–2017.06
RM2170E _51 Engine / Hybrid System _057007 1NZ-FXE EMISSION CONTROL _0277966 CANISTER G

1NZ-FXE EMISSION CONTROL  CANISTER  INSPECTION  


PROCEDURE

Hide 1.CHECK CHARCOAL CANISTER

a.

Inspect the ventilation of the canister.

i.
U183312E02
1.073,0.229 1.208,0.229 1.208,0.229 1.521,0.604 true 0.844,1.906 0.969,1.906 0.969,1.906 1.313,1.469 true 0.677,1.823 0.802,1.969 0.125,0.146 10 false A 0.906,0.146 1.031,0.292 0.125,0.146 10 false B 2.177,1.969 2.354,2.125 0.177,0.156 10 false *a

Apply compressed air into port A and check that air flows out from port B.

Text in Illustration
*a Air

If a problem is found, replace the fuel pump sub-assembly.



b.

Inspect the check valve.

i.
U183313E02
1.25,0.292 1.396,0.292 1.396,0.292 1.583,0.583 false 2.469,1.719 2.219,1.719 2.219,1.719 1.542,1.458 true 2.552,1.615 2.677,1.76 0.125,0.146 10 false A 1.094,0.198 1.219,0.344 0.125,0.146 10 false B 2.479,0.125 2.656,0.281 0.177,0.156 10 false *a

Close port A and apply compressed air into port B.

Text in Illustration
*a Air

OK:

Air does not flow at first. By gradually increasing the pressure, air flows when the pressure in the port reaches the specified level.



ii.
U183314E02
1.313,1.292 1.458,1.292 1.458,1.292 1.563,1.594 false 2.417,2.813 2.177,2.813 2.177,2.813 1.521,2.458 true 2.5,2.708 2.625,2.885 0.125,0.177 10 false A 1.135,1.208 1.26,1.354 0.125,0.146 10 false B

Close port A. Using a hand-held vacuum pump, apply a vacuum to port B.

OK:

The vacuum is maintained at first. By gradually increasing the vacuum, air flows and the vacuum decreases after the vacuum reaches the specified level.