77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
83320
2.REMOVE FUEL SENDER GAUGE ASSEMBLY
23220A
3.REMOVE FUEL PUMP WITH FILTER ASSEMBLY
Disconnect the connector of the fuel pump harness.
Disconnect the suction filter hose.
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, and remove the fuel filter and fuel pump with filter assembly from the No. 1 fuel sub-tank.
| *1 | No. 1 Fuel Sub-tank |
| *2 | Fuel Tube |
Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter, such as applying excessive force to the tube (See page Engine / Hybrid System>1NZ-FXE FUEL>FUEL SYSTEM>PRECAUTION).
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.
Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump with filter assembly from the fuel filter.
| *1 | Fuel Filter |
| *2 | Suction Filter |
Do not damage the fuel filter.
Do not remove the suction filter.
Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.
Disconnect the fuel pump harness connector.
Remove the O-ring and fuel pump spacer from the fuel pump with filter assembly.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
| *a | 5.0 mm (0.197 in.) |
Be careful not to damage the sealing surface.
If the O-ring still remains in the fuel filter assembly, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.
23280J
4.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator assembly.
Slowly pull out the fuel pressure regulator assembly because the O-ring is firmly installed between the fuel pressure regulator assembly and the fuel filter.
Remove the 2 O-rings from the fuel pressure regulator assembly.
| *1 | O-ring |