Home › Engine / Hybrid System › 1NZ-FXE INTAKE / EXHAUST › EXHAUST MANIFOLD › 2011.12–2017.06
RM2170E _51 Engine / Hybrid System _057008 1NZ-FXE INTAKE / EXHAUST _0277969 EXHAUST MANIFOLD A

1NZ-FXE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


PROCEDURE

Hide 25680 1.REMOVE EGR COOLER ASSEMBLY

Hide 17410 2.REMOVE FRONT EXHAUST PIPE ASSEMBLY

a.
A267686

Remove the 4 bolts and 4 compression springs.


b.

Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.


c.

Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.


Hide 17167 4.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

a.
A267688

Remove the 3 bolts and No. 1 exhaust manifold heat insulator.


Hide 25591 5.REMOVE MANIFOLD SUPPORT BRACKET

a.
A267692

Remove the 4 bolts and manifold support bracket.


Hide 25611A 6.REMOVE NO. 1 EGR PIPE

a.
A267693

Remove the bolt, nut and No. 1 EGR pipe.


b.

Remove the gasket.


Hide 17141 7.REMOVE EXHAUST MANIFOLD

a.
A268068

Disconnect the wire harness clamp and oxygen sensor connector.


b.
A267694

Remove the 3 bolts, 2 nuts and exhaust manifold.


c.

Remove the exhaust manifold to head gasket.


Hide 17168 8.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

a.
A268065

Remove the 3 bolts and No. 2 exhaust manifold heat insulator.