Home › Engine / Hybrid System › 1NZ-FXE (COOLING) › COOLING FAN ECU
RM2170E _51 Engine / Hybrid System _057009 1NZ-FXE COOLING _0277977 COOLING FAN ECU G

1NZ-FXE COOLING  COOLING FAN ECU  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89257 1.INSPECT COOLING FAN ECU

a.

Put the vehicle in the following conditions:

i.

The power switch is off.


ii.

The coolant temperature is less than 92°C (198°F).


iii.

The auxiliary battery voltage is between 11 to 14 V.


iv.

The A/C switch is off.



b.

Connect the pickup of a clamp-on ammeter over one of the two wires for the cooling fan motor.


c.

Turn the power switch on (IG) and wait for approximately 10 seconds. Check that the fan stops.


d.

Turn the power switch on (IG). Check that the fan stops with the engine idling.

HINT:
·

Make sure that the radiator engine coolant temperature is less than 92°C (198°F).


·

Turn the A/C switch off.




e.

Check that the fan operates when the A/C switch is turned on.

Standard Current:
Item Specified Condition
Cooling fan motor 12.2 to 15.7 A


HINT:

The coolant temperature is less than 92°C (198°F).



f.

Check that the fan operates when the engine coolant temperature sensor connector is disconnected.

Standard Current:
Item Specified Condition
Cooling fan motor 12.2 to 15.7 A



g.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


h.
A264604E02
1.315,0.231 2.547,0.413 1.232,0.181 10 Operating Diagram 1.734,0.725 2.324,0.880 0.590,0.156 10 A/C OFF 0.263,1.18 0.763,1.324 0.500,0.144 10 MAX HI 0.624,2.435 0.832,2.590 0.209,0.155 10 LO 0.055,1.686 0.489,2.017 0.434,0.331 10 Fan Speed 1.361,3.468 1.558,3.625 0.197,0.157 10 92 1.703,3.468 1.900,3.625 0.197,0.157 10 96 2.425,3.468 2.697,3.625 0.272,0.157 10 100 2.802,3.468 3.056,3.625 0.254,0.157 10 102 1.277,3.817 1.549,3.974 0.272,0.157 10 198 1.675,3.817 1.948,3.974 0.272,0.157 10 205 2.439,3.817 2.711,3.974 0.272,0.157 10 212 2.816,3.817 3.088,3.974 0.272,0.157 10 216 3.119,3.805 3.388,3.963 0.269,0.157 10 (°F) 3.112,3.458 3.390,3.650 0.277,0.192 10 (°C) 2.094,3.474 2.291,3.631 0.197,0.157 10 99 2.052,3.818 2.319,3.975 0.267,0.157 10 210

After the engine is warmed up, check that the fan operates as shown in the illustration.

HINT:
·

The coolant temperature at which the fan starts operating is approximately 96°C (205°F).

·

This system can also be checked using the intelligent tester.

·

Select the following menu items: Powertrain / Engine and ECT / Data List / Coolant Temp.