Home › Engine / Hybrid System › 1NZ-FXE (COOLING) › RADIATOR
RM2170E _51 Engine / Hybrid System _057009 1NZ-FXE COOLING _0277978 RADIATOR G

1NZ-FXE COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16520A 1.CHECK WATER FILLER CAP SUB-ASSEMBLY

a.
U113560E02
1.031,1.635 1.188,1.813 0.156,0.177 10 false 3 0.5,1.063 0.656,1.24 0.156,0.177 10 false 1 0.74,1.292 0.896,1.469 0.156,0.177 10 false 2 2.385,1.573 2.542,1.76 0.156,0.188 10 false 4

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the part(s) with water and finger scouring.


ii.

Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.


iii.

Check that 3 and 4 are not stuck together.


iv.

Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.


v.

When using the cap tester, tilt it upward 30° or more.


vi.
A104601E33
0.417,0.896 0.417,1.542 false 1.667,0.802 1.771,0.385 1.771,0.385 2.052,0.385 false 0.354,1.563 0.542,1.76 0.188,0.198 10 false *1 1.354,0.927 1.542,1.115 0.188,0.188 10 true *b 2.115,0.292 2.302,0.49 0.188,0.198 10 false *a

Pump the cap tester several times, and check the maximum pressure *1.

Text in Illustration
*1 Radiator Cap Tester
*2 Water Filler Cap Sub-assembly
*a 30° or more

Pumping speed:

1 pump every second


*1: Even if the cap cannot maintain the maximum pressure, it is not a defect.

Judgment Criterion:
Item Specified Condition
Standard value
(for brand-new cap)
93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value
(for used cap)
78.5 kPa (0.8 kgf/cm2, 11.4 psi)


If the maximum pressure is less than the specified pressure for the minimum standard value, replace the water filler cap sub-assembly.