Home › Engine / Hybrid System › 1NZ-FXE (LUBRICATION) › OIL AND OIL FILTER › 2011.12–2017.06
RM2170E _51 Engine / Hybrid System _057010 1NZ-FXE LUBRICATION _0277982 OIL AND OIL FILTER A

1NZ-FXE LUBRICATION  OIL AND OIL FILTER  REPLACEMENT  


CAUTION / NOTICE / HINT

CAUTION:
·

Prolonged and repeated contact with engine oil will cause the loss of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.

·

Wear protective clothing and gloves. Avoid contact with used oil. If contact occurs, wash your skin thoroughly with soap or waterless hand cleaner. Never use gasoline, thinners, or solvents to wash the skin.

·

In order to protect the environment, dispose of used oil and used oil filters at designated disposal sites only.



PROCEDURE

Hide 1.DRAIN ENGINE OIL

a.

Remove the oil filler cap.


b.

Remove the oil pan drain plug and gasket, and drain the oil into a container.


c.

Clean and install the oil drain plug with a new gasket.

Torque:
38 N*m (382 kgf*cm, 28 ft.*lbf)


Hide 15601 2.REMOVE OIL FILTER SUB-ASSEMBLY

a.

Using SST, remove the oil filter.

SST
09228-06501  


Hide 15601 3.INSTALL OIL FILTER SUB-ASSEMBLY

a.

Check and clean the oil filter installation surface.


b.

Apply clean engine oil to the gasket of a new oil filter.


c.

Lightly screw the oil filter into place by hand. Tighten it until the gasket contacts the seat.


d.

Using SST, tighten the oil filter.

SST
09228-06501  

i.

Depending on the work space available, choose from the following:

·

If enough space is available, use a torque wrench to tighten the oil filter.


Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)

·

If enough space is not available to use a torque wrench, tighten the oil filter a 3/4 turn by hand or use a common wrench.




Hide 4.ADD ENGINE OIL

a.

Add new oil.

Standard Oil Grade:
Oil Grade Oil Viscosity (SAE)
API grade SL "energy-conserving", SM "energy-conserving", SN "resource-conserving" or ILSAC multigrade engine oil
·

0W-20

·

5W-20

·

5W-30

·

10W-30


API grade SL, SM or SN multigrade engine oil
·

15W-40

·

20W-50




Standard Oil Capacity:
Item Standard Condition
Drain and refill with oil filter change 3.7 liters (3.9 US qts, 3.3 Imp. qts)
Drain and refill without oil filter change 3.4 liters (3.6 US qts, 3.0 Imp. qts)
Dry fill 4.1 liters (4.3 US qts, 3.6 Imp. qts)



b.

Install the oil filler cap.


Hide 5.INSPECT FOR OIL LEAK