Home › Engine / Hybrid System › 1NZ-FXE (LUBRICATION) › OIL PRESSURE SWITCH
RM2170E _51 Engine / Hybrid System _057010 1NZ-FXE LUBRICATION _0277983 OIL PRESSURE SWITCH G

1NZ-FXE LUBRICATION  OIL PRESSURE SWITCH  INSPECTION  


PROCEDURE

Hide 83530 1.INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

a.

Disconnect the oil pressure switch connector.


b.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


c.

Start the engine.


d.
A159695

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Switch body Idling 10 kΩ or higher
1 - Switch body Engine stopped Below 1 Ω


If the result is not as specified, replace the oil pressure switch assembly.


e.

Reconnect the oil pressure switch connector.