Home › Engine / Hybrid System › 1NZ-FXE STARTING › POWER SWITCH
RM2170E _51 Engine / Hybrid System _057011 1NZ-FXE STARTING _0277984 POWER SWITCH G

1NZ-FXE STARTING  POWER SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT POWER SWITCH

a.

Measure the resistance according to the value(s) in the table below.

A260269E25
4.427,0.875 4.219,0.292 4.219,0.292 4.094,0.292 false 5.344,0.896 5.563,0.313 5.563,0.313 5.698,0.313 false 5.375,1.229 5.656,1.229 false 3.802,0.219 4.094,0.5 0.292,0.281 10 false SS1 5.75,0.229 6.042,0.531 0.292,0.302 10 false SS2 5.708,1.146 6.177,1.417 0.469,0.271 10 false AGND

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 (SS1) - 6 (AGND) Pushed Below 1 Ω
1 (SS2) - 6 (AGND) Pushed Below 1 Ω
5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
1 (SS2) - 6 (AGND) Not pushed 10 kΩ or higher


If the result is not as specified, replace the power switch.


b.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the power switch.

A260269E26
4.635,1.313 4.313,1.531 4.313,1.531 4.198,1.531 true 5.385,1.229 5.573,1.229 true 1.948,1.031 1.26,1.031 false 5.594,1.135 6.063,1.448 0.469,0.313 10 false AGND 3.823,1.448 4.344,1.708 0.521,0.26 10 false SWIL 1.083,0.927 1.271,1.177 0.188,0.25 10 false *a

Text in Illustration
*a Power Switch Illumination - -

Standard Resistance:
Measurement Condition Specified Condition
Auxiliary battery positive (+) →Terminal 9 (SWIL)
Auxiliary battery negative (-) →Terminal 6 (AGND)
Illuminates
(Power Switch Illumination)


If the result is not as specified, replace the power switch.