Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2011.12–2014.12
RM2170E _51 Engine / Hybrid System _057012 CRUISE CONTROL _0277986 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  U0122  Lost Communication with Vehicle Dynamics Control Module  


DESCRIPTION

The vehicle speed sensors send vehicle speed signals to the brake booster with master cylinder (skid control ECU). Signals are then sent to the power management control ECU.

DTC No. DTC Detection Condition Trouble Area
U0122 While power switch is on (IG), communication stop between brake booster with master cylinder assembly (skid control ECU) and power management control ECU continues for 2.6 seconds or more
·

Brake booster with master cylinder assembly (skid control ECU)

·

CAN communication system

·

Power management control ECU



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Connect the intelligent tester to the DLC3.


b.

Select "Bus Check" from the "System Select".


c.

Select "DTC" from the "Bus Check" screen, and then select "Enter".

Result:
Result Proceed to
CAN communication system DTC is not output A
CAN communication system DTC is output B




A

B

GO TO CAN COMMUNICATION SYSTEM