This DTC indicates an abnormality in the power management control ECU.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0575 | When both of the following conditions are met:
·
STP signals input to the power management control ECU supervisory CPU and control ECU are different for 0.15 seconds or more ·
0.4 seconds have passed after cruise cancel input signal (STP input) is input to the power management control ECU |
Power management control ECU |
The power management control ECU receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function activates and remains on until the power switch is turned off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Clear the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure that the DTC detection conditions are met.
If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control system on using the ON-OFF switch.
Push the -/SET switch to activate the cruise control.
Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC P0575 is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B