Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2014.12–2015.11
RM2170E _51 Engine / Hybrid System _057012 CRUISE CONTROL _0277986 CRUISE CONTROL SYSTEM C

CRUISE CONTROL  CRUISE CONTROL SYSTEM  P0575  Cruise Control Input Circuit  


DESCRIPTION

This DTC indicates an abnormality in the hybrid vehicle control ECU.

DTC No. DTC Detection Condition Trouble Area
P0575 When both of the following conditions are met:
·

STP signals input to the hybrid vehicle control ECU supervisory CPU and control ECU are different for 0.15 seconds or more

·

0.4 seconds have passed after cruise cancel input signal (STP input) is input to the hybrid vehicle control ECU


Hybrid vehicle control ECU

HINT:

The hybrid vehicle control ECU receives signals from each sensor to control all functions of the cruise control system. When a trouble code is detected, the fail-safe function activates and remains on until the power switch is turned off.


PROCEDURE

1.CHECK FOR DTCs (DTC P0575)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.



e.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.


i.

Drive the vehicle at a speed for which cruise control operation is possible.


ii.

Turn the cruise control system on using the ON-OFF switch.


iii.

Push the -/SET switch to activate the cruise control.



f.

Enter the following menus: Powertrain / Cruise Control / Trouble Codes.


g.

Check for DTCs.

Result:
Result Proceed to
DTC is not output A
DTC P0575 is output B




A

B