Home › Drivetrain › P510 (HYBRID TRANSMISSION / TRANSAXLE) › HYBRID TRANSAXLE FLUID
RM2170E _52 Drivetrain _057013 P510 HYBRID TRANSMISSION / TRANSAXLE _0277990 HYBRID TRANSAXLE FLUID A

P510 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE FLUID  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE HYBRID TRANSAXLE FLUID

a.

Be sure that the vehicle remains level and lift the vehicle. [*1]


b.
C249711

Using a 10 mm hexagon socket wrench, remove the filler plug and gasket. [*2]


c.
C249712

Using a 10 mm hexagon socket wrench, remove the drain plug and gasket to drain the hybrid transaxle fluid. [*3]


d.

Using a 10 mm hexagon socket wrench, temporarily install the drain plug and gasket. [*4]

HINT:

Because the drain plug will be removed again, the gasket can be reused at this time.



e.
C249713E01
2.451,0.573 2.635,0.736 0.184,0.163 10 *1 2.416,0.665 2.326,0.665 2.326,0.665 2.148,1.081 false

Add transaxle fluid until the fluid level is between 0 to 8 mm (0 to 0.315 in.) from the bottom lip of the filler plug opening. [*5]

Text in Illustration
*1 Filler Nozzle

NOTICE:
·

Use Toyota Genuine ATF WS.

·

Be sure to fully insert the filler nozzle into the filler plug opening.

·

Be sure to add fluid slowly. If fluid is added quickly, the fluid may hit internal parts and bounce back, resulting in fluid coming out of the filler plug opening.

·

Be sure to directly check that the transaxle fluid level is within the specified range.

·

Insufficient or excessive amounts of transaxle fluid may damage the hybrid transaxle.




f.

Using a 10 mm hexagon socket wrench, temporarily install the filler plug and gasket. [*6]

HINT:

Because the filler plug will be removed again, the gasket can be reused at this time.



g.

Lower the vehicle. [*7]


h.

Connect the intelligent tester to the DLC3 and turn the power switch on (IG). [*8]


i.

Put the engine in inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE). [*9]


j.

Idle the engine for 30 seconds with the power switch on (READY). [*10]


k.

Turn the power switch off. [*11]


l.

Repeat steps [*1] to [*11].


m.

Repeat steps [*1] to [*3].


n.

Using a 10 mm hexagon socket wrench, install the drain plug and a new gasket.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)