Home › Drivetrain › P510 (HYBRID TRANSMISSION / TRANSAXLE) › SHIFT LEVER POSITION SENSOR › 2011.12–2017.06
RM2170E _52 Drivetrain _057013 P510 HYBRID TRANSMISSION / TRANSAXLE _0277993 SHIFT LEVER POSITION SENSOR A

P510 HYBRID TRANSMISSION / TRANSAXLE  SHIFT LEVER POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 51442C 1.REMOVE ENGINE UNDER COVER LH

Hide 33820B 2.SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C249709

Remove the nut and clip and separate the transmission control cable assembly from the transmission control shaft lever and No. 1 transmission control cable bracket.


Hide 89451A 3.REMOVE SHIFT LEVER POSITION SENSOR

a.
C250068

Disconnect the connector from the shift lever position sensor.


b.
C250069

Remove the nut, washer, and transmission control shaft lever from the shift lever position sensor.


c.
C250070E05
1.74,1.458 1.583,1.823 1.583,1.823 1.479,1.823 false 1.271,1.729 1.427,1.896 0.156,0.167 10 true *1

Using a screwdriver, pry the tabs of the lock plate.

Text in Illustration
*1 Lock Plate


d.
C250071E06
2.146,1.208 2.25,0.906 2.25,0.906 2.344,0.906 false 1.833,1.427 1.729,1.729 1.729,1.729 1.646,1.729 false 2.375,0.813 2.531,0.979 0.156,0.167 10 true *1 1.438,1.646 1.594,1.813 0.156,0.167 10 true *2

Remove the lock nut and lock plate from the manual valve shaft.

Text in Illustration
*1 Lock Nut
*2 Lock Plate


e.
C250072

Remove the 2 bolts and pull out the shift lever position sensor from the manual valve shaft.


f.
C251614E03
1.979,1.115 2.542,1.75 2.542,1.75 2.646,1.75 false 2.677,1.667 2.854,1.833 0.177,0.167 10 false *1

Using a screwdriver with its tip taped, remove the shift lever position sensor seal.

Text in Illustration
*1 Vinyl Tape

NOTICE:
·

It is not always necessary to replace or remove/install the shift lever position sensor seal at the same time when replacing the shift lever position sensor.

·

When removing the shift lever position sensor seal, be sure not to damage the case or manual shaft with the screwdriver.



HINT:

Remove/install the shift lever position sensor seal only if oil leaks from the shift lever position sensor seal or other faults are found when the shift lever position sensor is removed.