1.INSPECT SHIFT LEVER POSITION
While moving the shift lever from N to each position, check that the lever moves smoothly and that the shift position indicator comes on properly according to the shift lever position.
Turn the power switch on (READY) and check the following:
When the shift lever is moved to D, the vehicle moves forward.
When the shift lever is moved to R, the vehicle moves in reverse.
The vehicle should not move when the shift position indicator is off.
2.ADJUST SHIFT LEVER POSITION
Apply the parking brake and move the shift lever to N.
Remove the rear console box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL).
Slide the adjuster case cover in the direction shown by the arrow.
| *1 | Adjuster Case |
| *2 | Adjuster Case Cover |
Using a precision screwdriver, pull out the lock piece of the adjuster case.
| *1 | Adjuster Case |
| *2 | Lock Piece |
Using your fingers, gently pull the cable rod towards the rear of the vehicle to remove backlash.
Push in the lock piece of the adjuster case to lock it.
| *1 | Adjuster Case |
| *2 | Lock Piece |
| *3 | Cable Rod |
Move the adjuster case cover in the direction shown by the arrow.
| *1 | Adjuster Case |
| *2 | Lock Piece |
| *3 | Adjuster Case Cover |
If the adjuster case cover is not moved far enough so that the adjuster case cover engages the lock piece, the cable will not be able to lock, and reliable shift operation will not be possible.
Install the rear console box assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>INSTALLATION).