33504F
1.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
Move the shift lever to N.
Remove the shift lever knob sub-assembly.
2.REMOVE REAR CONSOLE BOX ASSEMBLY
33820B
3.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Disconnect the cable end from the shift lever assembly.
Rotate the nut approximately 180° in the direction shown in the illustration, and while holding the nut, disconnect the transmission control cable assembly from the shift lever plate.
| *1 | Nut |
| *a | Rotate Approximately 180° |
| *b | Disconnect |
Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.
4.REMOVE SHIFT LEVER ASSEMBLY
Disconnect the 2 connectors from the shift lever assembly.
Disengage the 2 clamps and separate the instrument panel wire from the shift lever assembly.
Remove the 4 bolts and shift lever assembly.