Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM2170E _52 Drivetrain _057015 AXLE AND DIFFERENTIAL _0278003 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43212 1.INSTALL STEERING KNUCKLE

a.
C363389E01
2.406,3.385 1.635,2.875 1.635,2.875 2.542,2.875 false 1.323,2.792 1.781,2.99 0.458,0.198 10 false SST

Using SST and a press, insert a new front axle hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.

SST
09950-60020  (09951-00720)
09950-70010  (09951-07100)

Text in Illustration
V100135

Inside of the Vehicle
V100145

Magnetic Rotor Side

NOTICE:
·

Do not remove the inner race because the hub bearing is built into the oil seal.

·

Do not use bearings that have been removed.

·

Do not wipe off any grease that has been applied to new bearings.

·

Do not bring magnets close to the magnetic rotor surface of the bearing.

·

Keep the magnetic rotor surface of the bearing free of foreign matter.




Hide 47782 2.INSTALL FRONT DISC BRAKE DUST COVER

a.
C243642E01
2.32,0.348 2.452,0.512 0.131,0.164 10 A 2.519,1.324 2.651,1.489 0.131,0.164 10 A

Provisionally install a new front disc brake dust cover, as shown in the illustration.

Standard distance A:

19.8 mm (0.78 in.)



b.
C243001E02
2.46,0.439 2.817,0.602 0.357,0.163 10 SST 2.443,0.527 2.003,0.527 2.003,0.527 2.003,0.775 false

Using SST and a hammer, install the front disc brake dust cover.

SST
09223-56010  

NOTICE:
·

Uniformly press in the disc brake dust cover while sliding SST slightly.

·

Press in the front disc brake dust cover until it is securely seated to the pressing-in base.




c.
C249886

Using a chisel, stake the 3 points on the circumference.

NOTICE:

Securely fold each end into the engagement grooves.



Hide 43502C 3.INSTALL FRONT AXLE HUB SUB-ASSEMBLY

Hide 43502G 4.INSTALL FRONT AXLE HUB HOLE SNAP RING

Hide 5.INSTALL FRONT AXLE ASSEMBLY