Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM2170E _52 Drivetrain _057015 AXLE AND DIFFERENTIAL _0278003 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

·

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT AXLE ASSEMBLY

Hide 43502G 2.REMOVE FRONT AXLE HUB HOLE SNAP RING

Hide 43502C 3.REMOVE FRONT AXLE HUB SUB-ASSEMBLY

Hide 47782 4.REMOVE FRONT DISC BRAKE DUST COVER

a.
C107919

Remove the front disc brake dust cover by tapping the back with a brass bar and hammer.


Hide 43212 5.REMOVE STEERING KNUCKLE

a.

Install the removed front axle hub bearing inner race onto the outer side of the front axle hub bearing.


b.
C112580E09
2.281,1.583 1.823,1.813 1.823,1.813 2.281,1.25 true 2.563,0.302 1.854,0.302 1.854,0.302 2.344,0.49 true 1.5,1.729 1.802,1.948 0.302,0.219 10 true SST 1.51,0.219 1.813,0.365 0.302,0.146 10 false SST

Using SST and a press, remove the front axle hub bearing.

SST
09223-15020  
09387-02010  
09950-60010  (09951-00630)
09950-70010  (09951-07100)