Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM2170E _53 Suspension _057018 REAR SUSPENSION _0278012 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48760B 1.INSTALL REAR SUSPENSION SUPPORT ASSEMBLY

a.

Install the rear suspension support assembly to the rear shock absorber assembly.


Hide 48752A 2.INSTALL REAR SUSPENSION SUPPORT STOPPER

a.

Install the rear suspension support stopper to the rear shock absorber assembly.


Hide 48540 3.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

a.

Insert the upper end of the rear shock absorber assembly to the vehicle body.


b.

Support the spring seat of the rear axle beam assembly using a jack and wooden block.


c.

Jack up the rear axle beam assembly slowly, and provisionally install the rear shock absorber assembly (lower side) with the bolt and nut onto the rear axle beam assembly.

NOTICE:

Since a stopper nut is used, turn the bolt.


HINT:

Insert the bolt with the threaded end facing the outside of the vehicle.



d.

Install the rear suspension support and rear shock absorber cushion retainer.


e.
C106033E02
0.395,0.488 0.624,0.661 0.229,0.174 10 (A)

While holding the piston rod, install a new nut (lower nut) to the specified standard.

Standard (A):

15 to 18 mm (0.591 to 0.709 in.)



f.

Install a new nut (upper nut) onto the lower nut.


g.
C338970

Hold the lower nut and tighten the upper nut against it.

Torque:
25 N*m (250 kgf*cm, 18 ft.*lbf)


Hide 58732C 4.INSTALL REAR ABSORBER CAP

a.

Engage the 2 guides and 2 claws to install the rear absorber cap.


Hide 5.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 6. STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Bounce the vehicle up and down several times to stabilize the suspension.


Hide 48540 7.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY

a.

Fully tighten the rear shock absorber assembly (lower side) with the bolt.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)

NOTICE:

Since a stopper nut is used, turn the bolt.