Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM2170E _53 Suspension _057018 REAR SUSPENSION _0278012 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 58732C 2.REMOVE REAR ABSORBER CAP

a.
C249967

Disengage the 2 claws and 2 guides, and remove the rear absorber cap.


Hide 48540 3.REMOVE REAR SHOCK ABSORBER ASSEMBLY

a.
C249973E03
2.229,1.948 1.615,1.948 false 1.844,1.604 1.615,1.604 false 1.427,1.521 1.594,1.688 0.167,0.167 10 false *1 1.438,1.844 1.604,2.01 0.167,0.167 10 false *2

Support the spring seat of the rear axle beam assembly using a jack and wooden block.

Text in Illustration
*1 Wooden Block
*2 Jack

CAUTION:

Do not jack up the rear axle beam assembly too high as the vehicle may fall.


NOTICE:

Keep supporting the rear axle beam assembly with a jack until the installation of the rear shock absorber assembly is complete.



b.
C354334

Remove the 2 nuts while keeping the piston rod from rotating.


c.

Remove the rear shock absorber cushion retainer and rear suspension support.


d.
C106031E03
2.219,1.969 1.667,1.969 false 1.833,1.615 1.656,1.615 false 1.479,1.531 1.635,1.698 0.156,0.167 10 false *1 1.49,1.896 1.646,2.063 0.156,0.167 10 false *2

Remove the bolt while holding the nut and remove the rear shock absorber assembly.

Text in Illustration
*1 Wooden Block
*2 Jack

NOTICE:

Since a stopper nut is used, turn the bolt.



Hide 48752A 4.REMOVE REAR SUSPENSION SUPPORT STOPPER

Hide 48760B 5.REMOVE REAR SUSPENSION SUPPORT ASSEMBLY