Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER › from 2015.11
RM2170E _53 Suspension _057019 TIRE PRESSURE MONITORING _0278015 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  INSTALLATION  


PROCEDURE

Hide 897A0 1.INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
C248377

Connect the connector to the tire pressure warning ECU and receiver.


b.
C404043C02
0.365,0.302 0.677,0.5 0.313,0.198 10 false *A 2.104,0.302 2.417,0.5 0.313,0.198 10 false *B
*A for Type A
*B for Type B


Engage the 2 hooks to temporarily install the tire pressure warning ECU and receiver.


c.

Install the bolt.

Torque:
for Type A : 10 N*m (102 kgf*cm, 7 ft.*lbf)
for Type B : 5.5 N*m (56 kgf*cm, 49 in.*lbf)

NOTICE:

There are 3 types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.



Hide 62472A 2.INSTALL ROOF SIDE INNER GARNISH LH