Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER › from 2015.11
RM2170E _53 Suspension _057019 TIRE PRESSURE MONITORING _0278015 TIRE PRESSURE WARNING RECEIVER A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST).


PROCEDURE

Hide 62472A 1.REMOVE ROOF SIDE INNER GARNISH LH

Hide 897A0 2.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
C248376

Remove the bolt.


b.

Disengage the 2 hooks to remove the tire pressure warning ECU and receiver.


c.
C248377

Disconnect the connector from the tire pressure warning ECU and receiver.