Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2015.11
RM2170E _53 Suspension _057019 TIRE PRESSURE MONITORING _0278018 TIRE PRESSURE WARNING SYSTEM U

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TERMINALS OF ECU  


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER


a.
U183579E02
0.337,1.088 0.663,1.259 0.326,0.170 10 M48 0.144,0.088 0.353,0.274 0.209,0.186 10 *a

Disconnect the M48 tire pressure warning ECU and receiver connector and measure the voltage or resistance on the wire harness side.

Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
M48-1 (IG) - M48-12 (GND) L - W-B IG power source Power switch on (IG) 10 to 16 V
M48-7 (+B) - M48-12 (GND) BR - W-B Power supply (from auxiliary battery) Always 10 to 16 V
M48-12 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω


b.

Connect the M48 tire pressure warning ECU and receiver connector.


c.

Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may be malfunctioning.

HINT:

Inspect the connectors from the back side while the connectors are connected.


U183660E02
0.115,0.09 0.442,0.337 0.327,0.247 10 *a 2.013,0.877 2.337,1.029 0.324,0.152 10 M48

Text in Illustration
*a Component with harness connected
(Tire Pressure Warning ECU and Receiver)
- -

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
M48-3 (CLSW) - M48-12 (GND) B - W-B Tire pressure warning reset switch
·

Power switch on (IG)

·

Tire pressure warning reset switch on


Below 1.5 V
·

Power switch on (IG)

·

Tire pressure warning reset switch off


8 to 15 V
M48-4 (RDA) - M48-12 (GND) R - W-B Output signals Power switch on (IG) Pulse generation (see waveform 1)
M48-5 (PRG) - M48-12 (GND) W - W-B Input signals Power switch on (IG) Pulse generation (see waveform 1)


d.
C240058E07
2.87,1.132 3.114,1.339 0.244,0.207 10 *b 0.103,0 0.310,0.216 0.207,0.216 10 *a

Using an oscilloscope, check waveform 1.

Text in Illustration
*a Example
*b GND

Waveform 1:
Item Contents
Terminal M48-4 (RDA) - M48-12 (GND)
M48-5 (PRG) - M48-12 (GND)
Tool setting 5 V/DIV, 5 ms./DIV.
Vehicle condition Power switch on (IG)

HINT:

The waveform shown in the illustration is an example. If the tester displays a waveform that alternates between high and low, where high is a voltage that is between the IG power source voltage and a voltage 2.2 V lower than the IG power source voltage, and where low is a voltage of between 0 and 1.2 V, the ECU can be judged normal.