Home › Brake › BRAKE (REAR) › REAR BRAKE
RM2170E _54 Brake _057024 BRAKE (REAR) _0278038 REAR BRAKE G

BRAKE (REAR)  REAR BRAKE  INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust and scoring. If necessary, replace the brake cylinder assembly or piston.


Hide 2.INSPECT BRAKE DRUM INSIDE DIAMETER

a.
F006408

Using a brake drum gauge or an equivalent tool, measure the inside diameter of the drum.

Standard inside diameter:

228.6 mm (9.00 in.)


Maximum inside diameter:

229.6 mm (9.04 in.)


If the inside diameter is more than the maximum, replace the drum.


Hide 3.INSPECT REAR BRAKE SHOE LINING THICKNESS

a.
F042690

Using a ruler, measure the thickness of the shoe lining.

Standard thickness:

5.0 mm (0.197 in.)


Minimum thickness:

1.0 mm (0.0394 in.)


If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the brake shoe.

NOTICE:

Always replace both the right and left drum brake shoes together.



Hide 4.INSPECT BRAKE DRUM AND DRUM BRAKE SHOE LINING FOR PROPER CONTACT

a.
C151738

Apply chalk to the inside surface of the drum, then slide the brake shoe against the drum to check the fit of the brake lining to the drum.

If the contact between the drum and the brake shoe lining is improper, repair it using a brake shoe grinder or replace the brake shoe.