1.ADJUST REAR DRUM BRAKE SHOE CLEARANCE
2.INSPECT PARKING BRAKE LEVER TRAVEL
Firmly pull the parking brake lever.
Release the parking brake lever lock and return it to its off position.
Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
8 to 11 notches at 200 N (20 kgf, 45.0 lbf)
If the parking brake lever travel is not as specified, adjust the parking brake lever travel.
3.ADJUST PARKING BRAKE LEVER TRAVEL
Release the parking brake lever lock and return it to its off position.
Remove the rear console box (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL).
Turn the lock nut until the parking brake lever travel is corrected to within the specified range.
| *1 | Lock nut |
8 to 11 notches at 200 N (20 kgf, 45.0 lbf)
If the lock nut has been removed from the rod, replace the lock nut with a new one.
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
Check that the parking brake does not drag.
Install the rear console box (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>INSTALLATION).
4.INSPECT BRAKE WARNING LIGHT
When operating the parking brake lever, check that the brake warning light illuminates.
The brake warning light always illuminates at the first click.