Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM2170E _55 Steering _057027 STEERING COLUMN _0278050 STEERING COLUMN ASSEMBLY G

STEERING COLUMN  STEERING COLUMN ASSEMBLY  INSPECTION  


PROCEDURE

Hide 1.INSPECT PRELOAD

a.
C248051E02
2.104,1.646 2.479,1.646 false 0.844,1.167 0.531,1.073 0.531,1.073 0.885,1.073 false 0.323,0.99 0.49,1.135 0.167,0.146 10 false *1 2.49,1.552 2.677,1.719 0.188,0.167 10 false *2

Secure the steering column assembly in a vice using aluminum plates and wooden block as shown in the illustration.

Text in Illustration
*1 Aluminum Plate
*2 Wooden Block

NOTICE:

When using a vise, do not overtighten it.



b.
C249608E02
1.698,1.427 2.229,1.427 true 2.271,1.354 2.729,1.635 0.458,0.281 10 false SST

Using SST and a torque wrench, turn the main shaft at a constant speed of approximately 1 revolution every 4 seconds and measure the preload.

SST
09616-00011  

Torque:
Preload : 1.4 N*m (14 kgf*cm, 12 in.*lbf)

or less


If the preload is not as specified, replace the power steering motor assembly or electric power steering column sub-assembly with a new one.


Hide 2.INSPECT STEERING COLUMN ASSEMBLY

a.
C235885

Check that the 2 bushings are securely installed to the steering column assembly.

If the bushings are deformed, missing or damaged, replace the electric power steering column sub-assembly with a new one.


b.
C234253E02
1.442,0.073 1.599,0.226 0.157,0.153 10 *1 1.049,0.165 1.417,0.165 1.417,0.165 1.045,1.136 false 1.829,0.872 2.024,1.049 0.195,0.177 10 *a 2.746,0.863 2.941,1.040 0.195,0.177 10 *b

Check that the 2 capsules are securely installed to the electric power steering column sub-assembly as shown in the illustration.

Text in Illustration
*1 Capsule
*a OK
*b NG

Standard:

Capsules do not overlap the corner parts of the brackets.


NOTICE:
·

If the standard value is not satisfied, replace the electric power steering column sub-assembly with a new one.

·

If the capsules have deformation, damage or misalignment, replace the electric power steering column sub-assembly with a new one.