Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM2170E _55 Steering _057027 STEERING COLUMN _0278050 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 45020A 1.REMOVE STEERING LOCK ACTUATOR ASSEMBLY

a.

Secure the steering column assembly in a vise between aluminum plates.

NOTICE:

Do not overtighten the vise.



b.

Using a drill, drill a hole in the steering lock set bolt, to insert a screw extractor.


c.
C232526

Using the screw extractor, remove the steering lock set bolt and remove the steering lock actuator assembly.


Hide 2.REMOVE POWER STEERING MOTOR ASSEMBLY (for LHD)

NOTICE:
·

Do not drop the power steering motor assembly, strike it with tools or subject it to impacts.

·

If the power steering motor assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness and tilt steering support bond cable of the power steering motor assembly.

·

Do not allow any moisture to come into contact with the power steering motor assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign objects to contaminate the power steering motor assembly.



a.
C243853

Cut the clamp, and remove the clamp and the 3 pieces of tape from the wire harness.

NOTICE:

When removing the clamp and the tape, be careful not to damage the wire harness.



b.
C241870

Remove the 2 bolts and power steering motor assembly from the electric power steering column sub-assembly.


Hide 3.REMOVE POWER STEERING MOTOR ASSEMBLY (for RHD)

NOTICE:
·

Do not drop the power steering motor assembly, strike it with tools or subject it to impacts.

·

If the power steering motor assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness and tilt steering support bond cable of the power steering motor assembly.

·

Do not allow any moisture to come into contact with the power steering motor assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign objects to contaminate the power steering motor assembly.



a.

Cut the No. 1 clamp, and remove the No. 1 clamp from the electric power steering column sub-assembly.


b.
C234654

Disengage the claw and remove the No. 1 steering column protector.


c.
C234655

Disengage the No. 2 clamp from the No. 1 steering column protector.


d.

Cut the No. 2 clamp and No. 3 clamp, and remove the clamps and the 2 pieces of tape from the wire harness.

NOTICE:

When removing the clamp and the tape, be careful not to damage the wire harness.



e.
C234656

Remove the 2 bolts and power steering motor assembly from the electric power steering column sub-assembly.