86160
1.INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
Using an air riveter or a hand riveter, install the front No. 1 speaker assembly with 3 new rivets.
| *1 | Riveter | *2 | Mandrel |
| *a | INCORRECT | *b | CORRECT |
Do not touch the cone part of the speaker.
Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.
Confirm that the rivets are seated properly against the speaker.
Do not tilt the riveter when installing the rivets to the speaker.
Do not leave any clearance between the rivet heads and speaker.
Do not leave any clearance between the speaker and door. Firmly hold the 2 items together while installing the rivets.
Install the rivets in the order shown in the illustration.
If the rivet cannot be cut, pull it once and cut it.
Connect the connector.
86160P
2.INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
Install the front No. 2 speaker assembly with the 2 screws.
Do not touch the cone part of the speaker.
Connect the connector.
67602
3.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
4.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
5.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)