Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER
RM2170E _56 Audio / Visual / Telematics _057029 AUDIO / VIDEO _0278054 REAR DOOR SPEAKER A

AUDIO / VIDEO  REAR DOOR SPEAKER  REMOVAL  


PROCEDURE

Hide 67673A 1.REMOVE REAR DOOR FRAME GARNISH

Hide 2.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 67604 3.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 86160B 4.REMOVE REAR SPEAKER ASSEMBLY

a.
E237145

Disconnect the connector.


b.
E237146

Using a drill bit with a diameter of less than 5 mm (0.197 in.), drill out the 3 rivet heads and remove the rear speaker assembly.

NOTICE:
·

Do not touch the cone part of the speaker.

·

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

·

Be careful as the cut rivet will be very hot.




c.

Continue drilling and push out the remaining rivet fragments.


d.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.