Home › Audio / Visual / Telematics › AUDIO / VIDEO › NOISE FILTER › from 2013.12
RM2170E _56 Audio / Visual / Telematics _057029 AUDIO / VIDEO _0278059 NOISE FILTER G

AUDIO / VIDEO  NOISE FILTER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 86011R 1.INSPECT RADIO SETTING CONDENSER

a.

With the radio setting condenser installed, check that there is no looseness or other abnormalities.


b.
E386541C13
1.01,0.479 1.594,0.479 false 0.906,0.406 1.063,0.604 0.156,0.198 10 false 1 0.146,0.146 0.458,0.344 0.313,0.198 10 false *a
*a Radio Setting Condenser


Measure the resistance of the radio setting condenser according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Body ground
·

Power switch off

·

Window defogger off


Below 1 Ω



c.

Remove the bolt.


d.

Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.


e.
E230106C38
2.083,1.583 2.542,1.427 false 1.344,1.594 0.813,1.427 false 2.563,1.333 2.677,1.49 0.115,0.156 11 false 3 0.708,1.313 0.823,1.469 0.115,0.156 10 false 2 0.063,0.073 0.271,0.229 0.208,0.156 10 false *a
*a Radio Setting Condenser


Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - 3
·

Power switch off

·

Window defogger off


10 kΩ or higher


Standard Voltage:
Tester Connection Condition Specified Condition
2 - Body ground
·

Power switch on (IG)

·

Window defogger off


Below 1 V
2 - Body ground
·

Power switch on (IG)

·

Window defogger on


11 to 14 V