Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM2170E _56 Audio / Visual / Telematics _057029 AUDIO / VIDEO _0278060 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Radio Receiver Power Source Circuit  


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM

E211811E09
0.525,0.763 1.887,0.953 1.362,0.191 10 from Auxiliary Battery 0.831,1.953 1.890,2.144 1.059,0.191 10 from ACC Relay 3.71,1.001 4.190,1.191 0.480,0.191 10 DOME 3.766,2.178 4.158,2.368 0.392,0.191 10 ACC 5.882,0.664 6.000,0.855 0.118,0.191 10 4 6.064,1.953 6.455,2.144 0.391,0.191 10 ACC1 5.868,1.855 5.986,2.046 0.118,0.191 10 3 5.49,4.636 5.798,4.827 0.309,0.191 10 G37 6.064,3.186 6.483,3.377 0.419,0.191 10 GND1 5.49,4.819 7.142,5.009 1.652,0.191 10 Radio Receiver Assembly 5.887,3.088 6.005,3.279 0.118,0.191 10 7 6.064,0.763 6.360,0.953 0.296,0.191 10 +B1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - AUXILIARY BATTERY, BODY GROUND)
a.

Disconnect the radio receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G37-7 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G37-4 (+B1) - G37-7 (GND1) Power switch off 11 to 14 V
G37-3 (ACC1) - G37-7 (GND1) Power switch on (ACC) 11 to 14 V




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR