Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2011.12–2017.06
RM2170E _56 Audio / Visual / Telematics _057029 AUDIO / VIDEO _0278060 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  USB Audio System Recognition/Play Error  


DESCRIPTION

When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by the radio receiver assembly. This diagnosis procedure is for when a device is not recognized, or files from the device cannot be played normally.

WIRING DIAGRAM

E238680E04
0.661,1.089 1.127,1.310 0.466,0.221 10 UDO- 0.801,0.468 1.054,0.689 0.253,0.221 10 UPI 0.675,2.177 1.094,2.398 0.419,0.221 10 UJSG 0.647,1.64 1.066,1.861 0.419,0.221 10 UDO+ 0.661,2.778 1.080,2.999 0.419,0.221 10 UJSS 6.153,1.089 6.619,1.310 0.466,0.221 10 US1- 6.153,0.468 6.554,0.689 0.401,0.221 10 USV1 6.153,2.177 6.572,2.398 0.419,0.221 10 UGD1 6.153,1.64 6.572,1.861 0.419,0.221 10 US1+ 6.153,2.778 6.572,2.999 0.419,0.221 10 USG1 1.16,0.369 1.293,0.589 0.133,0.221 10 1 1.16,1.001 1.293,1.222 0.133,0.221 10 2 1.16,1.538 1.293,1.759 0.133,0.221 10 3 1.16,2.08 1.293,2.301 0.133,0.221 10 4 1.16,2.682 1.293,2.903 0.133,0.221 10 5 0.152,3.143 0.571,3.305 0.419,0.162 10 G44 0.152,3.289 2.687,3.481 2.534,0.192 10 No. 1 Stereo Jack Adapter Assembly 3.318,2.904 4.006,3.140 0.687,0.236 10 (Shielded) 5.937,0.369 6.070,0.589 0.133,0.221 10 1 5.937,0.996 6.070,1.216 0.133,0.221 10 2 5.937,1.538 6.070,1.759 0.133,0.221 10 3 5.937,2.08 6.070,2.301 0.133,0.221 10 4 5.937,2.682 6.070,2.903 0.133,0.221 10 5 5.462,3.143 5.826,3.305 0.364,0.162 10 G75 5.462,3.289 7.092,3.462 1.630,0.173 10 Radio Receiver Assembly

CAUTION / NOTICE / HINT

HINT:
·

When a large amount of data is in a USB device, it may take a while before play begins.

·

When using a USB device, files that are copy protected or encrypted due to copyright reasons cannot be played.

·

When files are not played in the sorted order, perform the following procedure before inspection.

(a)

Add numbers in front of the file names.

(b)

Put the files in a folder and copy the folder data to the USB device.




PROCEDURE

1.CHECK USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.


b.

Check if playable files are present on the USB device or "iPod".

HINT:

Refer to System Description for playable files (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>SYSTEM DESCRIPTION).



c.

Check if the USB device is a compatible format or "iPod" is a compatible version.

HINT:

Refer to System Description for compatible formats and versions (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>SYSTEM DESCRIPTION).


Result:
Condition Proceed to
No playable files exist, or incompatible device format or version A
Playable files exist, and compatible device format or version B




A

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR NO PLAYABLE FILES PRESENT

B

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the radio receiver assembly and No. 1 stereo jack adapter assembly connectors.


b.
U183671E02
1.885,1.469 2.271,1.469 false 2.26,1.781 1.75,1.49 false 1.51,1.479 0.979,1.802 false 2.26,1.948 1.708,1.563 false 0.917,1.469 1.375,1.469 false 1.5,3.927 1.031,3.646 false 1.5,4.094 1.031,4.094 false 1.781,3.927 2.396,3.719 false 1.781,4.094 2.313,4.094 false 1.729,4.24 2.313,4.385 false 1.49,0.385 1.844,0.531 0.354,0.146 10 false G44 2.302,1.385 2.844,1.563 0.542,0.177 10 false UJSG 0.635,1.396 0.927,1.573 0.292,0.177 10 false UPI 0.135,0.125 0.406,0.302 0.271,0.177 10 false *a 0.115,2.625 0.302,2.802 0.188,0.177 10 false *b 2.292,1.708 2.75,1.885 0.458,0.177 10 false UDO+ 0.625,1.771 1.021,1.948 0.396,0.177 10 false UDO- 2.302,1.938 2.698,2.115 0.396,0.177 10 false UJSS 0.552,3.521 0.969,3.698 0.417,0.177 10 false UGD1 2.427,3.604 2.844,3.781 0.417,0.177 10 false USV1 2.344,4.375 2.76,4.552 0.417,0.177 10 false USG1 0.542,4 0.958,4.177 0.417,0.177 10 false US1+ 2.354,4 2.771,4.177 0.417,0.177 10 false US1- 1.531,2.885 1.885,3.031 0.354,0.146 10 false G75

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G44-1 (UPI) - G75-1 (USV1) Always Below 1 Ω
G44-2 (UDO-) - G75-2 (US1-) Always Below 1 Ω
G44-3 (UDO+) - G75-3 (US1+) Always Below 1 Ω
G44-4 (UJSG) - G75-4 (UGD1) Always Below 1 Ω
G44-5 (UJSS) - G75-5 (USG1) Always Below 1 Ω
G44-1 (UPI) - Body ground Always 10 kΩ or higher
G44-2 (UDO-) - Body ground Always 10 kΩ or higher
G44-3 (UDO+) - Body ground Always 10 kΩ or higher
G44-4 (UJSG) - Body ground Always 10 kΩ or higher
G44-5 (UJSS) - Body ground Always 10 kΩ or higher


Text in Illustration
*a Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)
*b Front view of wire harness connector
(to Radio Receiver Assembly)



OK

3.INSPECT RADIO RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT RADIO RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)
a.

Reconnect the radio receiver assembly connector.


b.
U183670E02
1.458,2.094 0.99,1.792 false 1.969,2.083 2.365,2.083 false 0.635,2.146 0.99,2.292 0.354,0.146 10 false G44 0.719,1.635 0.979,1.781 0.26,0.146 10 false UPI 0.156,0.083 0.417,0.229 0.26,0.146 10 false *a 2.385,2 2.781,2.146 0.396,0.146 10 false UJSG

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
G44-1 (UPI) - G44-4 (UJSG) Power switch on (ACC) 5 V


Text in Illustration
*a Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)



OK

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK

NG

REPLACE RADIO RECEIVER ASSEMBLY

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK
a.

Delete all files in the USB device or "iPod" and format/restore it.


b.

Save the data again and check if it can be played on the in-vehicle device.

NOTICE:

Formatting a USB device or restoring an "iPod" erases all music on the device.

Ensure that backup music data is available before performing this operation.


OK:

Malfunction disappears.




OK

END

NG

5.REPLACE USB DEVICE OR "iPod"
5.REPLACE USB DEVICE OR "iPod"
a.

Turn the power switch off.

HINT:

When this malfunction occurs, it is necessary to turn off the power switch to make it possible for the vehicle to recognize a new device when it is connected.



b.

Turn the power switch on (ACC).


c.

Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

·

Refer to System Description for compatible formats and versions (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>SYSTEM DESCRIPTION).





NEXT

6.CHECK USB DEVICE OR "iPod"
6.CHECK USB DEVICE OR "iPod"
a.

Check if a USB device or "iPod" is recognized by the radio receiver assembly, and if information such as track, artist and album names are displayed on the screen.

OK:

Malfunction disappears.




OK

USB DEVICE OR "iPod" WAS INCOMPATIBLE OR DEFECTIVE

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE