Home › Power Source / Network › 1NZ-FXE BATTERY / CHARGING › AUXILIARY BATTERY › 2011.12–2014.12
RM2170E _57 Power Source / Network _057031 1NZ-FXE BATTERY / CHARGING _0278063 AUXILIARY BATTERY A

1NZ-FXE BATTERY / CHARGING  AUXILIARY BATTERY  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 4.REMOVE AUXILIARY BATTERY

a.
A267414

Remove the 2 nuts.


b.

Remove the battery clamp.


c.
A267415

Open the battery terminal cap.


d.

Loosen the nut, and disconnect the positive (+) battery terminal.


e.

Disconnect the battery ventilation hose.


f.

Remove the battery.


g.

Remove the battery insulator.