| Detection Item | Symptom | Trouble Area |
|---|---|---|
| Hybrid Vehicle Control ECU Communication Stop Mode | Either condition is met:
·
|
·
Hybrid vehicle control computer assembly branch line or connector ·
Power source circuit of hybrid vehicle control computer assembly ·
Hybrid vehicle control computer assembly ground circuit ·
Hybrid vehicle control computer assembly |
Before measuring the resistance of the CAN bus, turn the power switch off and leave the vehicle for 1 minute or more without operating the key or any switches, or opening or closing the doors. After that, disconnect the cable from the negative (-) auxiliary battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.
DTC check procedure: Turn the power switch on (IG), turn the cruise control system on using the cruise control main switch (ON/OFF switch), wait at least 60 seconds, and then drive the vehicle at a speed of 20 km/h (12 mph) or more.
After the repair, perform CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).
Inspect the fuses for circuits related to this system before performing the following procedure.
Operating the power switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
Disconnect the cable from the negative (-) auxiliary battery terminal.
Disconnect the G81 hybrid vehicle control computer assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
|---|---|---|
| G81-25 (CA1H) - G81-24 (CA1L) | Cable disconnected from negative (-) auxiliary battery terminal | 54 to 69 Ω |
| *a | Rear view of wire harness connector
(to Hybrid Vehicle Control Computer Assembly) |
OK
NG
Reconnect the G81 hybrid vehicle control computer assembly connector.
Disconnect the G80 hybrid vehicle control computer assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
|---|---|---|
| G80-6 (E1) - Body ground | Cable disconnected from negative (-) auxiliary battery terminal | Below 1 Ω |
| *a | Rear view of wire harness connector
(to Hybrid Vehicle Control Computer Assembly) |
OK
NG
Reconnect the G80 hybrid vehicle control computer assembly connector.
Connect the cable to the negative (-) auxiliary battery terminal.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Value |
|---|---|---|
| A71-4 (+B1) - Body ground | Power switch on (IG) | 11 to 14 V |
| A72-1 (+B2) - Body ground | Power switch on (IG) | 11 to 14 V |
| *a | Component with harness connected
(Hybrid Vehicle Control Computer Assembly) |
OK
NG