This DTC is stored when there is an open, short or ECU communication malfunction between the power management control ECU and certification ECU (smart key ECU assembly).
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2287 | There is an open, short or ECU communication malfunction between power management control ECU and certification ECU (smart key ECU assembly). | ·
Power management control ECU ·
Certification ECU (smart key ECU assembly) ·
Wire harness or connector |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
If the certification ECU (smart key ECU assembly) or power management control ECU is replaced, refer to Service Bulletin.
When using the intelligent tester to troubleshoot with the power switch off:
Connect the intelligent tester to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the intelligent tester and vehicle begins.
Clear the DTC (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs.
Check for both "Entry&Start" and "Power Source Control" DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B2287 is output. | A |
| DTC B2287 and B2785 are output simultaneously. | B |
When DTC B2287 and B2785 are output simultaneously, perform troubleshooting for DTC B2785 first.
A
B
Disconnect the G57 and G58 power management control ECU connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G57-6 (E1) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G57-1 (AM22) - Body ground | Power switch off | 11 to 14 V |
| G58-7 (AM21) - Body ground | Power switch off | 11 to 14 V |
OK
NG
Disconnect the G54 certification ECU (smart key ECU assembly) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G58-11 (LIN2) - G54-12 (LIN) | Always | Below 1 Ω |
| G58-11 (LIN2) - Body ground | Always | 10 kΩ or higher |
OK
NG
Check that the entry lock and unlock function operates normally (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>SMART ENTRY AND START SYSTEM (for Entry Function)>OPERATION CHECK).
Entry lock and unlock function operates normally.
OK
NG