| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B278C | An internal malfunction occurs in the certification ECU (smart key ECU assembly). | Certification ECU (smart key ECU assembly) |
When using the intelligent tester with the power switch off, connect the intelligent tester to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start (CAN). While using the intelligent tester, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the intelligent tester and the vehicle.
If the certification ECU (smart key ECU assembly) is replaced, refer to Service Bulletin.
Clear the DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
DTC B278C is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG