Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM › from 2015.11
RM2170E _57 Power Source / Network _057033 NETWORKING _0278069 LIN COMMUNICATION SYSTEM C

NETWORKING  LIN COMMUNICATION SYSTEM  B278C  Lost Communication with Power Source Control  


DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
B278C An internal malfunction occurs in the certification ECU (smart key ECU assembly).

Certification ECU (smart key ECU assembly)



CAUTION / NOTICE / HINT

NOTICE:
·

When using the intelligent tester with the power switch off, connect the intelligent tester to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start (CAN). While using the intelligent tester, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the intelligent tester and the vehicle.

·

If the certification ECU (smart key ECU assembly) is replaced, refer to Service Bulletin.



PROCEDURE

1.CLEAR DTC

NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).

OK:

DTC B278C is not output.




OK

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)