DESCRIPTION
The ECU stores trouble codes when malfunctions occur.
The diagnostic system allows for reading of the trouble codes from the DLC3.
Use the intelligent tester to help diagnose and repair the problem.
CHECK DLC3
Check the DLC3 (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION).
INSPECT AUXILIARY BATTERY VOLTAGE
Measure the vehicle auxiliary battery voltage with the power switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery.
SELF-DIAGNOSTIC MODE (USING INTELLIGENT TESTER)
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry&Start / Utility / Wireless Door Lock Diagnosis Mode.
Proceed to the next step in accordance with the prompts on the intelligent tester screen.
Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern.
Check the diagnostic outputs when an electrical key transmitter sub-assembly switch is held down. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer patterns.
| Wireless Door Lock Buzzer Output | Suspected Area |
|---|---|
| A | Normal (No malfunction) |
| B | Register wireless code |
| C | Wave interference or malfunction of a related component |