Home › Vehicle Interior › DOOR LOCK › BACK DOOR LOCK
RM2170E _58 Vehicle Interior _057034 DOOR LOCK _0278076 BACK DOOR LOCK G

DOOR LOCK  BACK DOOR LOCK  INSPECTION  


PROCEDURE

Hide 69350 1.INSPECT BACK DOOR LOCK ASSEMBLY

a.

Check the operation of the door lock motor.

i.
E345500E01
0.365,0.135 0.677,0.333 0.313,0.198 10 false *b 0.417,2.51 0.729,2.708 0.313,0.198 10 false *c

E345501E01
1.698,1.771 1.698,1.271 false 1.25,1.698 1.5,1.698 1.5,1.698 1.5,1.281 false 2.146,1.698 1.896,1.698 1.896,1.698 1.896,1.281 false 0.083,0.104 0.396,0.302 0.313,0.198 10 false *a 0.99,1.594 1.302,1.792 0.313,0.198 10 false D+ 1.542,1.813 2,2.052 0.458,0.24 10 false ACT- 2.208,1.625 2.667,1.865 0.458,0.24 10 false ACT+

Move the door lock to the lock position.


ii.

Apply auxiliary battery voltage to the door lock motor and check the operation of the door lock motor.

OK:
Connection Result
Auxiliary battery positive (+) → 1 (ACT+)
Auxiliary battery negative (-) → 2 (ACT-)
Unlocks


If the result is not as specified, replace the back door lock assembly.



b.

Check the operation of the door courtesy switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (ACT-) - 3 (D+) Locked 10 kΩ or higher
2 (ACT-) - 3 (D+) Unlocked Below 1 Ω


Text in Illustration
*a Component without harness connected
(Back Door Lock Assembly)
*b Lock
*c Unlock

If the result is not as specified, replace the back door lock assembly.