Home › Vehicle Interior › DOOR LOCK › TRANSMITTER BATTERY › 2011.12–2015.11
RM2170E _58 Vehicle Interior _057034 DOOR LOCK _0278078 TRANSMITTER BATTERY A

DOOR LOCK  TRANSMITTER BATTERY  REPLACEMENT  


PROCEDURE

Hide 89745C 1.REMOVE TRANSMITTER BATTERY

NOTICE:

Take extra care when handling these precision electronic components.


a.
B279472

Push the release hook knob and extract the mechanical key as shown in the illustration.


b.
B279473E03
1.625,1.156 2.073,1.469 true 2.104,1.427 2.396,1.635 0.292,0.208 10 false *1

Insert a screwdriver into the gap, and turn the screwdriver to detach the transmitter housing cover.

Text in Illustration
*1 Protective Tape

HINT:

Tape the screwdriver tip before use.



c.
B279474E01
2.023,0.292 2.312,0.533 0.290,0.241 10 *1 1.336,1.206 1.992,0.38 false

Insert a precision screwdriver into the gap and remove the transmitter battery (lithium battery: CR1632).

Text in Illustration
*1 Protective Tape

NOTICE:
·

Do not push the terminals with your finger.

·

Do not forcibly pry up the transmitter battery. The terminals may be damaged.

·

Do not touch the transmitter battery with wet hands. Water may cause rust.

·

Do not touch or move any components inside the transmitter. It may interfere with proper operation.

·

To prevent the transmitter from being damaged, be sure to touch a grounded metal surface with your bare hands to discharge any static electricity before replacing the transmitter battery.



HINT:

Tape the screwdriver tip before use.



Hide 89745C 2.INSTALL TRANSMITTER BATTERY

a.
B279475

Install a new transmitter battery (lithium battery: CR1632) with the positive (+) side facing upward as shown in the illustration.

NOTICE:
·

Be sure that the positive (+) side and the negative (-) side of the transmitter battery are matched correctly.

·

Be careful not to bend the electrodes while installing the transmitter battery.

·

Keep the interior of the transmitter case free of dust, water and oil.

·

To prevent the transmitter from being damaged, be sure to touch a grounded metal surface with your bare hands to discharge any static electricity before replacing the transmitter battery.




b.
B279476

Install the transmitter housing cover by pressing down on it as shown in the illustration.


c.
B279477

Insert the mechanical key into the transmitter.


d.

Press one of the transmitter switches and check that the LED illuminates.

OK:

Transmitter LED illuminates when switch is pressed.