Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART ENTRY AND START SYSTEM (for Start Function) › from 2014.12
RM2170E _58 Vehicle Interior _057035 THEFT DETERRENT / KEYLESS ENTRY _0278081 SMART ENTRY AND START SYSTEM(for Start Function) C

THEFT DETERRENT / KEYLESS ENTRY  SMART ENTRY AND START SYSTEM(for Start Function)  U0140  Lost Communication with Main Body ECU  U0142  Lost Communication with Main Body ECU  U0155  Lost Communication with Combination Meter  U0293  Lost Communication with HV ECU  


DESCRIPTION

These DTCs are stored when there is a CAN communication error between the certification ECU (smart key ECU assembly) and the ECM, main body ECU (multiplex network body ECU), combination meter assembly or hybrid vehicle control ECU.

HINT:

When the cable is disconnected and reconnected to the negative (-) auxiliary battery terminal, the power source mode returns to the state it was in before the cable was disconnected.


DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation
U0140 CAN communication error between the certification ECU (smart key ECU assembly) and main body ECU (1-trip detection logic*) Main body ECU (Multiplex network body ECU) Always
U0142 CAN communication error between the certification ECU (smart key ECU assembly) and main body ECU (1-trip detection logic*) Main body ECU (Multiplex network body ECU) Always
U0155 CAN communication error between the certification ECU (smart key ECU assembly) and combination meter assembly (1-trip detection logic*) Combination meter assembly Turn the power switch on (IG) and wait 10 seconds or more.
U0293 CAN communication error between the certification ECU (smart key ECU assembly) and hybrid vehicle control ECU (1-trip detection logic*) Hybrid vehicle control ECU Turn the power switch on (IG) and wait 10 seconds or more.

*: Only detected while a malfunction is present and the power switch is on (IG)


Vehicle Condition and Fail-safe Function when Malfunction Detected
DTC Code Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
U0140 The warning (meter buzzer) does not sound and the meter does not indicate a warning. -
U0142
·

Doors cannot be locked or unlocked. The warning (wireless buzzer) does not sound.

·

The warning (meter buzzer) does not sound and the meter does not indicate a warning.


-
U0155
·

The warning (meter buzzer) does not sound and the meter does not indicate a warning. (When the smart key ECU stores the DTC.)

·

There is no effect on vehicle behavior. (When the smart key ECU stores the DTC.)


-
U0293 The warning (meter buzzer) does not sound and the meter does not indicate a warning. -

CAUTION / NOTICE / HINT

NOTICE:
·

When using the intelligent tester with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins, or 2) connect the intelligent tester to the vehicle, select the vehicle type under manual mode, and then enter the following menus:

for Power Source Control: Body / Power Source Control / DTC.

for Entry&Start: Body / Entry&Start / DTC.

·

After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.



HINT:
Related Data List and Active Test Items
DTC Data List Item Active Test Item
U0140
U0142
U0155
U0293
- -