When the communication line (IMI - EFIO) between the hybrid vehicle control ECU and ID code box (immobiliser code ECU) is stuck high, the hybrid vehicle control ECU stores this DTC.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B279A | The communication line (IMI - EFIO) between the hybrid vehicle control ECU and ID code box (immobiliser code ECU) is stuck high (1 trip detection logic*). | ·
Wire harness or connector (disconnection or break in wire harness is main cause) ·
ID code box (immobiliser code ECU) ·
Hybrid vehicle control ECU |
Turn the power switch on (IG) and wait 6 seconds. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Hybrid control system cannot be started | Hybrid control system cannot be started |
| DTC Code | Data List and Active Test |
|---|---|
| B279A | - |
When replacing the ID code box (immobiliser code ECU) or hybrid vehicle control ECU, refer to Service Bulletin.
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
When DTC B279A and the certification ECU (smart key ECU assembly) DTC are output simultaneously, first perform troubleshooting for the certification ECU (smart key ECU assembly) DTC.
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
NEXT
Turn the power switch on (IG) and wait 10 seconds.
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B279A is output | A |
| DTC B279A and other DTCs are output | B |
If DTCs other than DTC B279A are output, troubleshoot those DTCs first.
A
B
Turn the power switch off.
Check that the connectors are properly connected to the hybrid vehicle control ECU and ID code box (immobiliser code ECU).
Connectors are properly connected.
OK
NG
Disconnect the G49 ID code box (immobiliser code ECU) connector.
Disconnect the G81 hybrid vehicle control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G49-4 (EFIO) - G81-22 (IMI) | Always | Below 1 Ω |
| G81-22 (IMI) - Body ground | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G81-22 (IMI) - Body ground | Always | Below 1 V |
OK
NG
Replace the ID code box (immobiliser code ECU) with a new one.
Refer to Service Bulletin.
NEXT
Register the recognition codes in the ECUs.
Refer to Service Bulletin.
NEXT
Register the ECU communication ID.
Refer to Service Bulletin.
NEXT
Clear the DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B279A is not output.
OK
NG