Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM › 2011.12–2014.12
RM2170E _58 Vehicle Interior _057035 THEFT DETERRENT / KEYLESS ENTRY _0278082 ENGINE IMMOBILISER SYSTEM C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM  B279C  Theft Deterrent System Presence Detection  


DESCRIPTION

This code is stored when a power management control ECU that is incompatible with the engine immobiliser system is installed to the vehicle.

DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation
B279C A power management control ECU that is incompatible with the engine immobiliser system is installed (1 trip detection logic*). Power management control ECU Check for DTCs.

*: Only output while a malfunction is present.


Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Hybrid control system cannot be started -

Related Data List and Active Test
DTC Code Data List and Active Test
B279C -

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the power management control ECU, refer to Service Bulletin.


PROCEDURE

1.REPLACE CURRENT POWER MANAGEMENT CONTROL ECU WITH PROPER POWER MANAGEMENT CONTROL ECU
a.

Replace the current power management control ECU with the proper power management control ECU (See page Power Source / Network>POWER DISTRIBUTION>POWER MANAGEMENT CONTROL ECU>REMOVAL).



NEXT

END