1.CUSTOMIZE LIGHTING SYSTEM (INT)
Customizing using the intelligent tester
The following items can be customized.
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.
Connect the intelligent tester to the DLC3.
Turn the power switch to on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Utility / Customize / Illuminated Entry.
Select the setting by referring to the table below.
| Tester Display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| Lighting Time | 15 s | Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the power switch from off to on (ACC) or on (IG).) | 7.5 s, 15 s or 30 s | Main body ECU (Multiplex network body ECU) |
| I/L when ACC OFF | ON | Lights up the power switch illumination and personal light when the power switch is turned from on (ACC) or on (IG) to off. | ON or OFF | |
| I/L ON W/Door Key Unlock | ON | Lights up the power switch illumination and personal light when doors are unlocked using a mechanical key or door control transmitter. | ON or OFF | |
| Room Light when Aprchd | ON | Lights up the power switch illumination and personal light when a key enters any actuation area around the doors. | ON or OFF |