Home › Vehicle Interior › LIGHTING (INT) › RELAY
RM2170E _58 Vehicle Interior _057036 LIGHTING (INT) _0278093 RELAY G

LIGHTING (INT)  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84270Q 1.INSPECT DOME CUT RELAY

a.
E222294E15
1.104,0.948 1.333,0.417 1.333,0.417 1.5,0.417 false 0.802,1 1,0.417 1,0.417 1.083,0.417 false 0.833,1.75 0.667,1.75 0.667,1.75 0.573,1.281 false 1.417,1.75 1.25,1.75 1.25,1.75 1.156,1.354 false 0.219,0.229 0.531,0.427 0.313,0.198 10 false *a 1.146,0.333 1.458,0.531 0.313,0.198 10 false 5 1.552,0.333 1.865,0.531 0.313,0.198 10 false 1 1.5,1.667 1.813,1.865 0.313,0.198 10 false 2 0.906,1.667 1.219,1.865 0.313,0.198 10 false 3

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Voltage is not applied between terminals 1 and 2 10 kΩ or higher
3 - 5 Voltage is applied between terminals 1 and 2 Below 1 Ω


Text in Illustration
*a Component without harness connected
(Dome Cut Relay)

If the result is not as specified, replace the dome cut relay.