81240
1.REMOVE NO. 1 ROOM LIGHT ASSEMBLY
Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws to remove the No. 1 room light lens.
| *a | Protective Tape |
| *b | Front |
Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws as shown in the illustration to separate the No. 1 room light housing.
| *a | Protective Tape |
| *b | Front |
Disengage the clamp.
| *1 | Room Light Switch Base |
Using a screwdriver, disengage the 4 claws to disconnect the room light switch base from the No. 1 room light housing.
81240B
2.REMOVE NO. 1 ROOM LIGHT BULB
Remove the No. 1 room light bulb from the room light switch base.