DATA LIST
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Warm up the engine.
Turn the power switch off.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus:
for Combination Meter: Body / Combination Meter / Data List.
for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.
for Engine and ECT: Powertrain / Engine and ECT / Data List.
Check the values by referring to the table below.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Tail Relay SW | Tail relay/OFF or ON | OFF: Tail relay off | - |
| ON: Tail relay on | |||
| ODO/TRIP Change SW | ODO/TRIP change switch/OFF or ON | OFF: Switch released | - |
| ON: Switch pushed | |||
| P-Seatbelt Buckle SW | Front passenger seat belt buckle switch/OFF or ON | OFF: Front passenger seat belt fastened (warning light off) | - |
| ON: Front passenger seat belt unfastened (warning light on) | |||
| Vehicle Speed Meter | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) | Almost the same as actual vehicle speed | - |
| Engine Rpm | Engine speed/Min.: 0 rpm, Max.: 12750 rpm | 900 to 1050 rpm: Idling | - |
| Coolant Temperature | Engine coolant temperature/Min.: -40°C (-40°F), Max.: 127.5°C (261.5°F) | After warming up: 75 to 100°C (167 to 212°F) | ·
After warming up the engine, the engine coolant temperature is 75 to 100°C (167 to 212°F). ·
After a long soak, the engine coolant temperature, intake air temperature and ambient air temperature are approximately equal. |
| Light Control Switch | Light control switch/OFF or ON | OFF: Light control switch off | - |
| ON: Light control switch not off | |||
| Multi Display Select Switch | DISP switch in the steering pad switch assembly/OFF or ON | OFF: DISP switch in the steering pad switch assembly not pressed | - |
| ON: DISP switch in the steering pad switch assembly pressed | |||
| +B Voltage Value | Auxiliary battery voltage/Min.: 0 V, Max.: 25.5 V | 11 to 16 V | - |
| Fuel Input | Fuel input/Min.: 0 L, Max.: 127.5 L | 10th segment illuminated: 31.7 to 36.0 | Unit: Liter |
| 9th segment illuminated: 28.5 to 31.7 | |||
| 8th segment illuminated: 25.4 to 28.5 | |||
| 7th segment illuminated: 22.1 to 25.4 | |||
| 6th segment illuminated: 19.2 to 22.1 | |||
| 5th segment illuminated: 16.2 to 19.2 | |||
| 4th segment illuminated: 12.7 to 16.2 | |||
| 3rd segment illuminated: 9.8 to 12.7 | |||
| 2nd segment illuminated: 6.9 to 9.8 | |||
| 1st segment illuminated: 4.5 to 6.9 | |||
| Ambient Temperature | Outside temperature/Min.: -40°C (-40°F), Max.: 87.5°C (189.5°F) | Almost the same as actual outside temperature | The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F) |
| HV System Indicator | Hybrid system indicator value/ Min.: -512%, Max.: 511% | -512 to 511 | - |
| Oil Pressure Switch | Oil pressure switch/OFF or ON | OFF: Engine started | - |
| ON: Engine not started | |||
| Turn Signal Switch (Right) | RH turn signal switch/OFF or ON | OFF: RH turn signal switch off | - |
| ON: RH turn signal switch on | |||
| Turn Signal Switch (Left) | LH turn signal switch/OFF or ON | OFF: LH turn signal switch off | - |
| ON: LH turn signal switch on | |||
| Hazard Flasher Switch | Hazard warning switch/OFF or ON | OFF: Switch released | - |
| ON: Switch pushed | |||
| Headlight Auto Leveling Switch | Headlight auto leveling control/OFF or ON | OFF: Headlight auto level control off | - |
| ON: Headlight auto level control on | |||
| Key Remind Sound | Cycle of the key reminder warning buzzer | The cycle of the key reminder warning buzzer/Normal, Slow, Fast | - |
| Driver Side Seatbelt Warning Buzzer | Condition of the seat belt warning buzzer/OFF or ON | OFF: The seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened | Displays customize setting of seat belt warning buzzer |
| ON: The seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver seat belt unfastened | |||
| Number of Trouble Code | The number of DTCs currently stored/0 to 255 | 0 | - |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Vehicle Speed | Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Coolant Temp | Coolant temperature/Min.: -40°C (-40°F), Max.: 140°C (284°F) | 75 to 100°C (167 to 212°F): After warming up | ·
Stored as Freeze Frame Data ·
This is the engine coolant temperature. |
|
|||
Enter inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).
ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
Check the operation by referring to the table below.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Speed Meter Operation | Speedometer | 0, 40, 80, 120, 160 km/h | - |
| Fuel Meter Operation | Fuel receiver gauge | OFF, EMPTY, 1/2, FULL | - |
| A/T Indicator Operation 1 | Shift selection indicator | OFF, D, N, R, P | - |
| A/T Indicator Operation 2 | Shift selection indicator | OFF, B | - |
| Indicat. Lamp Airbag | SRS warning light | OFF or ON | - |
| Driver Side Seat Belt | Driver or front passenger seat belt warning light | OFF or ON | - |
| Indicat. Lamp ABS | ABS warning light | OFF or ON | - |
| Indicat. Lamp Charge | Charge warning light | OFF or ON | - |
| Indicat. Lamp Slip | Slip indicator light | OFF or ON | - |
| Indicat. Lamp Beam | High beam indicator light | OFF or ON | - |
| Indicat. Lamp Tail | Tail indicator light | OFF or ON | - |
| Indicat. Lamp Fr FOG*1 | Front fog indicator light | OFF or ON | - |
| Indicat. Lamp Rr FOG*2 | Rear fog indicator light | OFF or ON | - |
| Indicat. Lamp Fuel | Fuel level warning light | OFF or ON | - |
| Indicat. Lamp ECB | Brake warning light / yellow (minor malfunction) | OFF or ON | - |
| Indicat. Lamp Cruise | Cruise control indicator light | OFF or ON | - |
| Indicat. Lamp Brake | Brake warning light / red (malfunction) | OFF or ON | - |
| Indicat. EPS | EPS warning light | OFF or ON | - |
| Master Warning | Master warning light | OFF or ON | - |
| Indicat. Ready (HV) | Ready indicator light | OFF or ON | - |
| Indicat. EV Mode | EV indicator light | OFF or ON | - |
| Indicat. SET | SET indicator light | OFF or ON | - |
| Indicat. VSC OFF | VSC OFF indicator light | OFF or ON | - |
| Indicat. ECO Mode | Eco mode indicator light | OFF or ON | - |
| EV Mode Indicator | EV mode indicator light | OFF or ON | - |
| Turn Signal (Left) Indicator | LH turn indicator light | OFF or ON | - |
| Turn Signal (Right) Indicator | RH turn indicator light | OFF or ON | - |
| Water temperature meter operation | Engine coolant temperature receiver gauge | Low, Normal, High | - |
| HV System Indicator | Hybrid system indicator | MIN, -50, 0, 100, 200, 300, 400, MAX | - |
| Meter Display 1 | Segment display / Multi-information display | OFF, 0, 1, 2, 3, 4, 5, 6, All | - |
| Meter Display 2 | Segment display | OFF, 7, 8, 9 | - |
*1: w/ Front Fog Light
*2: w/ Rear Fog Light
*3: Although the item is displayed on the intelligent tester, no warning light or indicator light is operated.