Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2015.11–2017.06
RM2170E _58 Vehicle Interior _057037 METER / GAUGE / DISPLAY _0278095 METER / GAUGE SYSTEM C

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0129  Lost Communication with Skid Control ECU  U0131  Lost Communication with Power Steering Control Module  U0142  Lost Communication with Main Body ECU  U0151  Lost Communication with Airbag ECU  


DESCRIPTION

The combination meter assembly communicates with the ECM or hybrid vehicle control ECU, brake booster with master cylinder assembly (skid control ECU), power steering ECU assembly, main body ECU (multiplex network body ECU), and airbag sensor assembly via the CAN communication system.

DTC No. DTC Detection Condition Trouble Area
U0100 When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with ECM or hybrid vehicle control ECU continues for 2 seconds or more


·

ECM

·

Hybrid vehicle control ECU

·

CAN communication system

·

Combination meter assembly


U0129 When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with brake booster with master cylinder assembly (skid control ECU) continues for 2 seconds or more


·

Brake booster with master cylinder assembly (Skid control ECU)

·

CAN communication system

·

Combination meter assembly


U0131 When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with power steering ECU assembly continues for 3 seconds or more


·

Power steering ECU assembly

·

CAN communication system

·

Combination meter assembly


U0142 When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with main body ECU (multiplex network body ECU) continues for 3 seconds or more


·

Main body ECU (Multiplex network body ECU)

·

CAN communication system

·

Combination meter assembly


U0151 When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with airbag sensor assembly continues for 10 seconds or more


·

Airbag sensor assembly

·

CAN communication system

·

Combination meter assembly



PROCEDURE

1.CONFIRM DTC OUTPUT
a.

Check if CAN communication DTCs are output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B


HINT:

If CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 first.




A

B